Langley Scissor Lift Certification

Langley Scissor Lift Certification - Lots of worksites and tradespeople like welders, masons and iron workers make use of scissor lift platforms to be able to help them reach elevated work places. The operation of a scissor lift is normally secondary to their trade. Thus, it is vital that all operators of these platforms be properly trained and certified. Lift manufacturers, regulators and industry work together to make sure that operators are trained in safely using work platforms.

Work platforms are also known as manlifts or AWPs. These equipment are stable and simple to utilize, even though there is always some risk because they raise people to heights. The following are several important safety concerns common to AWPs:

In order to protect those working around work platforms from accidental discharge of power because of close working proximities to power lines and wires, there is a minimum safe approach distance (MSAD). Voltage can arc across the air and cause injury to personnel on a work platform if MSAD is not observed.

Caution should be taken when lowering a work platform to ensure stability. The boom must be retracted, when you move the load toward the turntable. This would help maintain steadiness when the -platform is lowered.

The rules about tie offs do not mandate those working on a scissor lift to tie themselves off. Various groups will on the other hand, need their personnel to tie off in their employer guidelines, local regulations or job-specific risk assessment. The anchorage provided by the manufacturer is the only safe anchorage wherein harness and lanyard combinations must be connected.

It is vital to observe and not go beyond the maximum slope rating. The grade could be measured by laying a straight edge on the slope or by laying a board. Next, a carpenter's level could be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the straight edge's length, then multiplying by 100, the per cent slope can be determined.

A typical walk-around check has to be done to determine if the unit is mechanically safe. A site assessment determines if the work area is safe. This is important particularly on changing construction locations because of the risk of obstacles, contact with power lines and unimproved surfaces. A function test must be done. If the unit is used safely and correctly and proper shutdown measures are followed, the chances of accidents are greatly lessened.

Click to Download the pdf